 CAUTION |
| Use the following safety guidelines to help protect your
projector from potential damage and to ensure your own personal safety: |
- The lamp becomes very hot with use. Do not attempt to replace the lamp after use until
the projector has been allowed to cool down for at least 30 minutes, and follow all
instructions in "Changing the Lamp."
|
- Do not touch the bulb or the lamp glass at any time. The bulb may explode due to
improper handling, including the touching of the bulb or the lamp glass.
|
- To avoid damaging the projector, allow the cooling fan to run for 3 minutes before
turning off the projector.
|
- The remote control is equipped with a Class II laser that emits laser radiation. To
reduce the risk of injury, do not look directly into the laser light, and do not point the
laser light into anyone's eyes.
|
- Do not block the ventilation slots and openings on the projector.
|
- Disconnect the power cord from the electrical outlet if the projector is not used for a
long period of time.
|
- Do not use the projector in an extremely hot, cold, or humid environment.
|
- Do not use the projector in areas susceptible to excessive dust and dirt.
|
- Do not use the projector near any appliance that generates a strong magnetic field.
|
- Do not place the projector in direct sunlight.
|
- Do not look into the lens while the projector is on; the bright light may hurt your
eyes.
|
- To reduce the risk of fire or electric shock, do not expose the projector to rain or
moisture.
|
- To prevent electric shock, do not open or disassemble the projector further than what is
needed for lamp replacement.
|
- To avoid damaging the projector, ensure that the zoom lens is fully retracted before
moving the projector or placing the projector in its carrying case.
|
- Turn off the projector and disconnect it from the electrical outlet before cleaning it.
Use a soft cloth moistened with mild detergent to clean the display housing. Do not use
abrasive cleaners, waxes, or solvents.
|
