|
|
|
| Microprocessor type |
3.3-V P54C Intel� Pentium�
chip |
| Microprocessor speeds |
| Revision 1 |
Revision
2 |
| 90/60 MHz |
100/66 MHz |
| 100/66 MHz |
120/66 MHz |
| 120/60 MHz |
133/60 MHz |
| 133/66 MHz |
150/60 MHz |
| |
166/66 MHz |
|
 |
NOTE: The I J
Jumper block was not present on the first
revision of the system board. This block was
added when the 150 and 166 microprocessors were
introduced in January of 1996. Systems without
this jumper block will not support processor
speeds greater than 133/66 Mhz. The system is
supported as originally shipped only. No
processor or system board upgrades are available
through Dell. |
|
| Internal cache |
8-KB instruction |
| |
8-KB data |
| Math coprocessor |
internal |
| Microprocessor socket |
ZIF |
|
| System chip set |
Intel 82430FX PCIset |
| Data bus width |
64 bits |
| Address bus width |
32 bits |
| DMA
channels |
7 |
| Timers |
3 |
| Interrupt
levels |
15 |
| Flash BIOS EPROM |
128 KB |
| Serial port UART |
16550-compatible |
| Buffer |
16 bytes |
|
| Bus type |
ISA and PCI |
| ISA expansion slots |
4 (1 connector shares a
card-slot opening with a PCI connector) |
| PCI expansion slots |
4 (1 connector shares a
card-slot opening with an ISA connector) |
| ISA bus speed |
7.5 MHz with 120-MHz CPU |
| |
8.33 MHz with 100-MHz CPU |
| PCI bus speed |
30 MHz with 120-MHz CPU |
| |
33 MHz with 100-MHz CPU |
| PCI data transfer rate |
100 MB/sec |
| PCI data width |
32-bit |
|
| Architecture |
fast-page mode or EDO |
| Wait states |
near zero |
| SIMM sockets |
4 |
| SIMM
capacities |
4, 8, 16, and 32 MB |
| SIMM type |
32-bit, nonparity |
| Minimum RAM |
8 MB |
| Maximum RAM |
128 MB |
| Memory access time: |
|
tRAC
|
60 ns EDO or 70 ns fast-page
mode |
tCAC
|
20 ns |
| External
cache |
256-KB asynchronous |
| |
256-KB pipeline burst |
| |
512-KB pipeline burst module
* |
| Speed |
15 ns |
| Type |
nonremovable from daughter
board |
| BIOS address |
E0000 - FFFFFh |
| * The 512-KB
cache is standard on the P133c and optional on the P120c.
It is not currently available on the P90c and P100c. |
|
| Externally accessible bays |
(3) 5.25-inch bays |
| |
(1) 3.5-inch bay |
| Internally accessible bays |
(2) 1-inch bays |
|
| Externally accessible: |
|
Serial (DTE)
|
(2) 9-pin connectors
(16550-compatible) |
Parallel
|
(1) 25-hole connector
(bidirectional)
(AT-, PS/2-, ECP-compatible) |
| |
|
| Video |
(1) video card |
| PS/2-style keyboard |
(1) 6-pin mini-DIN |
| PS/2-compatible mouse |
(1) 6-pin mini-DIN |
| Internally
accessible: |
|
Primary EIDE
|
40-pin connector (hard-disk
drives only) |
Secondary EIDE
|
40-pin connector
(non-hard-disk EIDE devices) |
Diskette drive
|
34-pin connector |
|
| No on-board video in this system. |
|
|
| <Ctrl><Alt><\> |
toggles microprocessor speeds on 101-key
keyboard |
| <Ctrl><Alt><#> |
toggles microprocessor speeds on 102-key
keyboard |
|
| <Ctrl><Alt><Del> |
restarts (reboots) the computer |
|
NOTE: There are no hot-key combinations
for entering the system setup program. Press <Del>
when prompted. |
|
|
| DC power supply: |
|
Wattage
|
230 W |
Voltage
|
90 to 135 V at 60 Hz or 180 to 265 V at
50 Hz |
|
| Height |
40.64 cm (16 inches) |
| Width |
20.32 cm (8 inches) |
| Depth |
40.64 cm (16 inches) |
| Weight |
11.3 to 13.6 kg (25 to 30 lb) |
|
| Temperature: |
|
Operating
|
10 to
35C (50 to
95F) |
Storage
|
-40� to 65�C (-40� to 149�F) |
Relative humidity
|
8% to 80% (noncondensing) |
| Vibration: |
|
Operating
|
0.25 G at 3 to 300 Hz for 15 minutes |
Storage
|
0.5 G at 3 to 300 Hz for 15 minutes |
| Shock: |
|
Operating
|
5 G for 11 ms |
Storage
|
20 G with a velocity change of 1397
mm/sec |
| Altitude: |
|
Operating
|
-16 to 3048 m (-50 to 10,000 ft) |
Storage
|
-16 to 10,600 m (-50 to 35,000 ft) |
|
| FCC (U.S. only) |
Class B |
| DOC (Canada) |
Class B |
| CE |
Class B |
| FCC ID |
E2KP510CMT |
| UL: |
|
For computers set at 115 V  Use a UL-certified grounded
cable, type SVT or SJT, with a minimum of 18 American
wire gauge (AWG). The cable must be no longer than 15
feet and must have a parallel-blade, grounded plug rated
for 15 A. |
| For computers set at 230 V
(within the U.S.)
Use a UL-certified grounded cable, type SVT or SJT, with
a minimum of 18 AWG. The cable must be no longer than 15
feet and must have a tandem-blade, grounded plug rated
for 15 A/250 V. |
| For computers set at 230 V (outside the
U.S.) Use a grounded cable,
type SVT or SJT, with a minimum of 18 AWG. The cable must
be no longer than 15 feet, must be rated according to the
requirements of the country in which the equipment is to
be used, and must have a grounded plug. The cable should
be labeled "HAR" and should have the
appropriate safety approvals for each country. |
