The
proper operation of the function requires a computer with VESAｮ DPMS power
management capabilities. When used with a computer equipped with VESAｮ DPMS,
the display is ENERGY STAR-compliant.
As an ENERGY
STARｮ Partner, Dell Inc. has determined that this product
meets the ENERGY STARｮ guidelines for energy efficiency.
WARNING: This equipment has been tested and
found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate receiving
antenna.
Increase the separation between
the equipment and receiver.
Connect the equipment into an
outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an
experienced radio/TV technician for help.
This device
complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions:
This device may not cause
harmful interference.
This device must accept any
interference received including interference that may cause undesired
operation.
Instructions to
Users: This
equipment complies with the requirements of FCC (Federal Communication
Commission) equipment provided that following conditions are met.
Power cable: Shielded power cable
must be used.
Video inputs: The input signal
amplitude must not exceed the specified level.
CAUTION: Changes or
modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
We hereby declare, that all major safety requirements, concerning to CE-Mark Directive
(93/68/EEC) and Low Voltage Directive (73/23/EEC), Electromagnetic Compatibility
Directives (89/336/EEC, 92/31/EEC) are fulfilled, as laid out in the guidelines set down
by the member states of the EEC Commission.This declaration is valid for all
samples that are part of this declaration, which are manufactured according to the
production charts appendix.The standards relevant for the evaluation of electrical
safety & EMC requirements are as follows :
LVD : EN 60950:1997+A1+A2+A3+A4
EMC : EN 55024:1998, EN55022:1998, EN61000-3-2, 3:1995
1. Certificate of conformity / Test report
issued by :
LVD : NEMKO, TUV
EMC :Sporton
International Inc.
2. Technical documentation kept at :
Liteon
Technology Corp.
which will be made available upon
request. (Manufacturer)
This digital
apparatus does not exceed the Class B limits for radio noise emissions from
digital apparatus set out in the Radio Interference Regulations of the Canadian
Department of Communications.
Note that Canadian
Department of Communications (DOC) regulations provide, that changes or
modifications not expressly approved by Dell Inc. could void
your authority to operate this equipment.
This Class B
digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil
numerique de la classe B respecte toutes les exigences du Reglement sur le
materiel brouilleur du Canada.
This equipment
complies with the limits for a Class 2 digital device (devices used in or
adjacent to a residential environment) and conforms to the standards for
information technology equipment that are set by the Voluntary Control Council
for Interference for preventing radio frequency interference in residential
areas.
The equipment
should draw power from a socket with an attached protection circuit (a
three-prong socket). All equipment that works together (computer, monitor,
printer, and so on) should have the same power supply source.
The phasing
conductor of the room's electrical installation should have a reserve
short-circuit protection device in the form of a fuse with a nominal value no
larger than 16 amperes (A).
To completely
switch off the equipment, the power supply cable must be removed from the power
supply socket, which should be located near the equipment and easily
accessible.
A protection mark
"B" confirms that the equipment is in compliance with the protection
usage requirements of standards PN-93/T-42107 and PN-89/E-06251.
The following
information is provided on the device(s) described in this document in
compliance with the requirements of the official Mexican standards (NOM)
Exporter:
Dell Inc.
One Dell Way
Round Rock, TX 78682
Importer:
Dell Computer de
México,
Paseo de la Reforma 2620, 11th Floor
Col. Lomas Altas
Méxicio DF
CP 11950
Ship
to:
Dell
Computer de México,
S.A. de C.V. al Cuidado de Kuehne & Nagel
de México S. de R.I., Avenida Soles No. 55
Col. Peñon de los Baños, 15520 México, D.F.
Supply
voltage:
>
100/240 VAC
Frequency:
50/60
Hz
Current
consumption:
1.2
A
Información para NOM (únicamente para México)
La informaci
siguiente se proporciona en el dispositivo o en los dispositivos descritos en
este documento, en cumplimiento con los requisitos de la Norma Oficial Mexicana
(NOM):
Exporter:
Dell Inc.
One Dell Way
Round Rock, TX 78682
Importador:
Dell Computer de
México,
Paseo de la Reforma 2620, 11th Floor
Col. Lomas Altas
Méxicio DF
CP 11950
Embarcar
a:
Dell
Computer de México,
S.A. de C.V. al Cuidado de Kuehne & Nagel
de México S. de R.I., Avenida Soles No. 55
Col. Peñon de los Baños, 15520 México, D.F.
You have just purchased a TCO'99 approved and labeled product! Your choice has provided you with a product developed for professional use. Your purchase has also contributed to reducing the burden on the environment and also to the further development of environmentally adapted electronics products.
Why do we have environmentally labeled computers?
In many countries, environmental labeling has become an established method for encouraging the adaptation of goods and services to the environment. The main problem, as far as computers and other electronics equipment are concerned, is that environmentally harmful substances are used both in the products and during their manufacture. Since it is not so far possible to satisfactorily recycle the majority of electronics equipment, most of these potentially damaging substances sooner or later enter nature.
There are also other characteristics of a computer, such as energy consumption levels, that are important from the viewpoints of both the work (internal) and natural (external) environments. Since all methods of electricity generation have a negative effect on the environment (e.g. acidic and climate-influencing emissions, radioactive waste), it is vital to save energy. Electronics equipment in offices is often left running continuously and thereby consumes a lot of energy.
What does labeling involve?
This product meets the requirements for the TCO'99 scheme which provides for international and environmental labeling of personal computers. The labeling scheme was developed as a joint effort by the TCO (The Swedish Confederation of Professional Employees), Svenska Naturskyddsforeningen (The Swedish Society for Nature Conservation) and Statens Energimyndighet (The Swedish National Energy Administration).
Approval requirements cover a wide range of issues: environment, ergonomics, usability, emission of electric and magnetic fields, energy consumption and electrical and fire safety.
The environmental demands impose restrictions on the presence and use of heavy metals, brominated and chlorinated flame retardants, CFCs (freons) and chlorinated solvents, among other things. The product must be prepared for recycling and the manufacturer is obliged to have an environmental policy which must be adhered to in each country where the company implements its operational policy.
The energy requirements include a demand that the computer and/or display, after a certain period of inactivity, shall reduce its power consumption to a lower level in one or more stages. The length of time to reactivate the computer shall be reasonable for the user.
Labeled products must meet strict environmental demands, for example, in respect of the reduction of electric and magnetic fields, physical and visual ergonomics and good usability.
Below you will find a brief summary of the environmental requirements met by this product. The complete environmental criteria document may be ordered from:
TCO Development
SE-114 94 Stockholm, Sweden
Fax: +46 8 782 92 07
Email (Internet): development@tco.se
Current information regarding TCO'99 approved and labeled products may also be obtained via the Internet, using the address: http://www.tco-info.com/
Environmental requirements
Flame retardants
Flame retardants are present in printed circuit boards, cables, wires, casings and housings. Their purpose is to prevent, or at least to delay the spread of fire. Up to 30% of the plastic in a computer casing can consist of flame retardant substances. Most flame retardants contain bromine or chloride, and those flame retardants are chemically related to another group of environmental toxins, PCBs. Both the flame retardants containing bromine or chloride and the PCBs are suspected of giving rise to severe health effects, including reproductive damage in fish-eating birds and mammals, due to the bio-accumulative* processes. Flame retardants have been found in human blood and researchers fear that disturbances in foetus development may occur.
The relevant TCO'99 demand requires that plastic components weighing more than 25 grams must not contain flame retardants with organically bound bromine or chlorine. Flame retardants are allowed in the printed circuit boards since no substitutes are available.
Cadmium**
Cadmium is present in rechargeable batteries and in the colour-generating layers of certain computer displays. Cadmium damages the nervous system and is toxic in high doses. The relevant TCO'99 requirement states that batteries, the colour-generating layers of display screens and the electrical or electronics components must not contain any cadmium.
Mercury**
Mercury is sometimes found in batteries, relays and switches. It damages the nervous system and is toxic in high doses. The relevant TCO'99 requirement states that batteries may not contain any mercury. It also demands that mercury is not present in any of the electrical or electronics components associated with the labelled unit. There is however one exception. Mercury is, for the time being, permitted in the back light system of flat panel monitors as there today is no commercially available alternative. TCO aims on removing this exception when a mercury free alternative is available.
CFCs (freons)
The relevant TCO'99 requirement states that neither CFCs nor HCFCs may be used during the manufacture and assembly of the product. CFCs (freons) are sometimes used for washing printed circuit boards. CFCs break down ozone and thereby damage the ozone layer in the stratosphere, causing increased reception on earth of ultraviolet light with e.g. increased risks of skin cancer (malignant melanoma) as a consequence.
Lead**
Lead can be found in picture tubes, display screens, solders and capacitors. Lead damages the nervous system and in higher doses, causes lead poisoning. The relevant TCO?9 requirement permits the inclusion of lead since no replacement has yet been developed.
*Bio-accumulative is defined as substances which accumulate within living organisms
**Lead, Cadmium and Mercury are heavy metals which are Bio-accumulative.
WARNING: This equipment has been tested and
found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures: 
CAUTION: Changes or
modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
