HINT: Complete
instructions for installing
the palm rests are
included with the optional
color inserts.
Save and close any open files, exit any open programs, and shut down
the computer.
If the computer is connected to a docking device (docked), undock it.
See the documentation that came with your docking device for
instructions.
Keep the display open and tilt the computer back so that you can
access the bottom of the computer.
Slide and hold the latch release on the left side, and remove any device
installed in the module bay.
Slide and hold the latch release on the right side, and remove any
battery installed in the battery bay.
Locate the orange palm rest removal buttons. Firmly press the buttons
with the eraser end of a pencil (or a dull utensil smaller than your
finger) to release the palm rests.
Remove the palm rests.
To replace the palm rests, insert the tabs on the inside edge of the
palm rest into the slots on the computer. Then press along the outside
edges of the palm rest until it snaps into place.
