Back to Contents Page

Internal Card With Bluetooth® Wireless Technology

Dell™ Inspiron™ 6400/E1505 Service Manual

  Removing the Card

  Replacing the Card

Removing the Card

CAUTION: Before you perform the following procedures, follow the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as the back panel) on the computer.

NOTICE: To avoid damaging the system board, you must remove the main battery (see Before Working Inside Your Computer) before you begin working inside the computer.

NOTE: If you ordered an internal card with Bluetooth wireless technology with your computer, the card is already installed.

1. Follow the instructions in Before You Begin.
   
   

NOTE: Ensure that you have removed the main battery for access to the card.

2. Use a plastic scribe to pry the card door open.
   
   
3. Disconnect the card cable connector from the card, and remove the door with the card from the computer.
   
   
4. Slide the card out of the plastic brackets.
   
   

1	card door	2	card cable connector	3	internal card with Bluetooth wireless technology
4	plastic brackets (2)

Replacing the Card

1. To replace the card, connect the card to the cable, then insert it into the compartment.
   
   
2. Replace the card door by inserting the small center tab into the notch at the base of the compartment, and snap it into place.
   
   
3. Replace the battery.
   
   

Back to Contents Page