CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface, such as a connector on the back of the computer.
Remove the four M2 x 3-mm screws that secure the PC Card reader to the computer.
1
PC Card reader
2
M2 x 3-mm screws (4)
3
pull-tab
NOTICE: To avoid damaging the PC Card reader connector, do not rotate or rock the connector as you remove it. Use firm and even pressure to lift the pull-tab vertically.
Use the pull-tab to disconnect the PC Card reader connector from the system board.