CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface, such as a connector on the back of the computer.
Remove the four M2 x 3-mm screws that secure the PC Card reader to the computer.
1
PC Card reader
2
M2 x 3-mm screws (4)
3
pull tab
NOTICE: To avoid damaging the PC Card reader connector, do not rotate or rock the connector as you remove it. Use firm and even pressure to lift the pull tab vertically.
Use the pull tab to disconnect the PC Card reader connector from the system board.