CAUTION: Before you begin any of the procedures in this section, follow the steps in "Safety Instructions."
Ensure that all cables are connected, and fold cables out of the way.
Gently pull the power cables toward you so that they do not get caught underneath the drives.
Ensure that no tools or extra parts are left inside the computer.
Close the cover:
Pivot the cover down.
Press down on the right side of the cover until it closes.
Press down on the left side of the cover until it closes.
Ensure that both sides of the cover are locked. If not, repeat step 3.
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then
plug it into the computer.
Connect your computer and devices to electrical outlets, and turn them on.
After you open and close the cover, the chassis intrusion detector, if enabled, causes the following message to appear on the screen at the next computer start-up:
ALERT! Cover was previously removed.
Reset the chassis intrusion detector by entering system setup and changing the
Chassis Intrusion setting to Enabled or Enabled-Silent.
NOTE: If a setup password has been assigned by someone else, contact your network
administrator for information on resetting the chassis intrusion detector.
DELL'S NORMAL TERMS AND CONDITIONS APPLY AND ARE AVAILABLE ONLINE OR UPON REQUEST. While all efforts are made to check pricing and other errors, inadvertent errors do occur from time to time and Dell reserves the right to decline orders arising from such errors.
Product image on the page is for your reference only.
