13.3-Inch LCD Brackets and Carrier Tray Removal: Dell Inspiron 7000
13.3-Inch LCD Brackets and Carrier Tray Removal: Dell™ Inspiron™ 7000
| NOTICE: The metal on the carrier tray
is sharp. Be careful not to cut yourself. |
This procedure assumes that you have removed the front bezel
and the 13.3-inch LCD panel. To remove the brackets from the LCD
panel, follow these steps:
- Detach the LCD wire harness from connector CN1 on the top left side of the inverter
board.
- Remove the (4) 6-mm screws from the sides of the mounting brackets.
- Remove the brackets from the LCD panel.
To remove the 13.3-inch LCD panel from the carrier tray, follow these steps:
- Remove any Kapton tape covering the CCFL cable.
- Gently pull the cable out of its connector.
- Remove any Kapton tape from the LCD wire harness.
- Disconnect the LCD wire harness from the LCD panel.
- Lift the LCD panel out of carrier tray.
| 
