Back to Contents Page

Bluetooth Assembly

Dell™ Studio XPS™ 8000 Service Manual

  Removing the Bluetooth Assembly

  Replacing the Bluetooth Assembly

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

WARNING: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.

WARNING: Do not operate your computer with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, etc.) removed.

CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty.

Removing the Bluetooth Assembly

1. Follow the procedures in Before You Begin.
   
   
2. Remove the computer cover (see Removing the Computer Cover).
   
   
3. Remove the front bezel (see Removing the Front Bezel).
   
   
4. Disconnect the Bluetooth® assembly cable from the system board connector (see System Board Components).
   
   
5. Press the tab as shown in the illustration and pull the Bluetooth assembly.
   
   
6. Carefully slide and remove the Bluetooth assembly out from the front of the computer.
   
   

1	Bluetooth assembly	2	Bluetooth assembly tab
3	front panel	4	Bluetooth assembly cable

7. Set the Bluetooth assembly aside in a secure location.
   
   

Replacing the Bluetooth Assembly

1. Follow the procedures in Before You Begin.
   
   
2. Align the Bluetooth assembly tab to the Bluetooth assembly slot in the front panel, and push the Bluetooth assembly until it clicks into place.
   
   
3. Connect the Bluetooth assembly cable, to the system board connector (see System Board Components).
   
   
4. Replace the front bezel (see Replacing the Front Bezel).
   
   
5. Replace the computer cover (see Replacing the Computer Cover).
   
   
6. Connect your computer and devices to electrical outlets, and turn them on.
   
   

Back to Contents Page