Back to Contents Page

USB Daughter Card

Service Manual

  Removing the USB Daughter Card

  Replacing the USB Daughter Card

Removing the USB Daughter Card

CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.

1. Follow the instructions in Before Working on Your Computer.
   
   
2. Remove the hard drive (see Removing the Hard Drive).
   
   
3. Remove the WLAN card (see Removing a WLAN Card).
   
   
4. Remove the hinge cover (see Removing the Hinge Cover).
   
   
5. Remove the keyboard (see Removing the Keyboard).
   
   
6. Remove the display assembly (see Removing the Display Assembly).
   
   
7. Remove the palm rest (see Removing the Palm Rest).
   
   
8. Remove the M2.5 x 5-mm screw from the daughter card.
   
   
9. Disconnect the daughter card connector from the daughter card.
   
   
10. Remove the daughter card from the computer base.
    
    

1	daughter card connector	2	M2.5 x 5-mm screw
3	USB daughter card

Replacing the USB Daughter Card

CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.

NOTE: This procedure assumes that you have completed the removal procedure first.

1. Replace the M2.5 x 5-mm screw to secure the daughter card to the computer base.
   
   
2. Connect the daughter card connector to the daughter card.
   
   
3. Replace the palm rest (see Replacing the Palm Rest).
   
   
4. Replace the display assembly (see Replacing the Display Assembly).
   
   
5. Replace the keyboard (see Replacing the Keyboard).
   
   
6. Replace the hinge cover (see Replacing the Hinge Cover).
   
   
7. Replace the WLAN card (see Replacing a WLAN Card).
   
   
8. Replace the hard drive (see Replacing the Hard Drive).
   
   

Back to Contents Page